Where do these little dabs come from? And how can I make them less noticeable? Every entry point in each layer will cause a blob. You can make it less obvious if you arrange the entry points in a column, popularly referred to as a “seam”. Click into the “Slice” menu of CraftWare and look […]
If you find continuous little waves or “ringing” in your print, there could be a variety of things wrong, and these problems may be mechanical. The easy fixes to this are: to first make sure that it doesn’t do the same with another file/to make sure that the file is sliced and that your CraftBot […]
The simple fix to this is that you need to have the layer underneath sufficient enough in strength to support the hot stuff going on top of it. If you have a flat plane that is paper thin, and especially if there is insufficient support underneath, you may find that the layer on top can […]
If you are using a CraftBot then you should not get terrible shifting problems. However, it is not impossible to see this, and if so, it may be a sign of a mechanical fault which hopefully can be easily remedied. But first, we will check and see if another simple printing error is responsible, how […]
This is really something that, if you are not confident with the 3D model itself before printing, you must go in and fix yourself… but don’t worry, you can do so with just a few common sense steps using CraftWare. Let’s start out by saying that the standard setup for Extrusion Width (settings are located […]
