Aside from an entire layer of a print warping, you may have smaller arcs on highlighted regions, which in-turn commonly lead to more abstract mutation in the continual series of printing. The fix here is somewhat similar to your standard overheating procedure. Her’s some suggestions to fix your problem, make sure that your fans are […]
Supports are the additional build towers that help to, well, support your print and they are necessary to make certain prints exist -your can’t just print in thin air! CraftWare has a great auto-support option, designed to provide a high and safe success rate of getting the object that you want in the end, but custom […]
Here is a quick rundown to where your problem may be coming from: not enough filament coming through the extruder. Always, even if you aren’t experiencing big problems, make sure that you have clean passageways from time to time. Further explanations can be found in other help sections concerning “Clogging” and in CraftBot videos on youtube. […]
Stringing is that inconvenient situation in which you get those spiderweb looking hairs in the empty parts of your print, hanging between two solid areas. There are two main ways to fix these. The easiest may be to just print at a slightly lower temperature, in the situation that the temp is too high for […]
Every print has a different characteristic due to it’s physical qualities. While the default print settings will in general be able to get a great print from most any object, there are some exceptions you may come across in the situation in which you would like to to achieve the “optimal” results. Through experience you […]
