The new SIMPLIFY3D V5 generates GCODE not compatible with Craftbot Pr3Dator firmware. The slicer generated GCODE create M106 (fan controll) command with “P” parameter, not compatible.The solution is to create a post processor script in the SimpliFy3D, change. {DELETE “P0”} in the “Post Processing” tab.
When the printer is not detected by the CraftPrint or the FW update process stuck always a point you can try this program.
Sometimes the buildplate is too far or too close to the nozzle and the leveling knobs are not able to set the right position. In this case you can set the Z level by moving the little metal clamp on the left hand side of the buildplate. There is two scre holding the metal clamp […]
Octopi / Octoprint is a web based 3D printer management solution. You can find information and setting up the OctoPi or OctoPrint device here: https://octoprint.org/download/ On Craftbot side we recommend a good quality USB cable to connect the OctoPi device with Craftbot. These are the settings available from pr3Dator_firmware_2019-03-06. But please always use the latest […]
