Three easy fixes are: level the bed again (especially check that the nozzle is not too close or too far from the bed surface), make sure that your printing parameters fit with the materials that you are using (such as the ABS with a 110 Celsius heated build plate), and last-but-not-least, clean the bed of before […]
Where do these little dabs come from? And how can I make them less noticeable? Every entry point in each layer will cause a blob. You can make it less obvious if you arrange the entry points in a column, popularly referred to as a “seam”. Click into the “Slice” menu of CraftWare and look […]
If you find continuous little waves or “ringing” in your print, there could be a variety of things wrong, and these problems may be mechanical. The easy fixes to this are: to first make sure that it doesn’t do the same with another file/to make sure that the file is sliced and that your CraftBot […]
If you are using a CraftBot then you should not get terrible shifting problems. However, it is not impossible to see this, and if so, it may be a sign of a mechanical fault which hopefully can be easily remedied. But first, we will check and see if another simple printing error is responsible, how […]
Aside from an entire layer of a print warping, you may have smaller arcs on highlighted regions, which in-turn commonly lead to more abstract mutation in the continual series of printing. The fix here is somewhat similar to your standard overheating procedure. Her’s some suggestions to fix your problem, make sure that your fans are […]
