Calibration: Single: Dual: How to insert the buildplate: How to load filament: How to unload filament: How to update the firmware: How to replace the nozzle: How to do the Z leveling: NOTE: You do not have to remove the mainboard from the […]
PLA 1,75mm: 1kg = 325mABS 1,75mm: 1kg = 395mPETG 1,75mm: 1kg = 310mPMMA 1,75mm: 1 kg = 350mPC 1,75mm: 1kg = 335mASA 1,75mm: 1kg = 395mPC+PBT 1,75mm: 1kg = 350mPA 6/66 1,75mm: 0,75kg = 285mTPS 1,75mm: 0,75kg = 370mHIPS 1,75mm: 1kg = 395mPVA 1,75mm: 0,5kg = 180m
The offset calibration concept is: 1. Measure the farest Z position: (steps) between the Z home and Z max position. It can be different in 1/10 mm so we have to check it. Because the build plate can move if the power goes out we have to know the max steps to get back the proper position […]
Here are G / M / T codes that the CraftBot FLOW Generation printer can understand G codes: 0 X,Y,Z,E,F Linear move X: The position to move to on the X axisY: The position to move to on the Y axisZ: The position to move to on the Z axisE: The amount to extrude between […]
