Shell "Wiggle" at overhangs
Quote from Magori Andras on 2022-06-20, 11:08Dear Joel
If you set the bottom and top shell thickness to 0, you can practically turn off the top/bottom shell which I don't advise 🙂
If the wiggle disturbs you there are a few good trick to get rid of them.
1: Reduce the bottom shell thickness a little bit.
2: Add one more loop to the loops, so there will be loop instead off the blue fuzz.
3: Change the shell fill type to "Smart" or "Concentric"
Best Regards,
András
Dear Joel
If you set the bottom and top shell thickness to 0, you can practically turn off the top/bottom shell which I don't advise 🙂
If the wiggle disturbs you there are a few good trick to get rid of them.
1: Reduce the bottom shell thickness a little bit.
2: Add one more loop to the loops, so there will be loop instead off the blue fuzz.
3: Change the shell fill type to "Smart" or "Concentric"
Best Regards,
András