The Forum from now on is in READ ONLY mode. Thank you for participating, but this message board is being sunset.

Trouble to hold the position of the object when switching to manufacturing.

#1 · 2021-12-09, 20:45

Steps I Made.

load object, need transformormation. Use Y=90` . Object turns with flat side on the table. On auto apply click on , Apply transform.

Blue arrow turns upwarts to his start position. So far so good.

when i switch to Manufacturing , the object is turning in the wrong (start ) position.

Is this a Bug , or do I something wrong.

Pieter.

#2 · 2021-12-12, 19:38

Problemen Solved.

printer installed , so I Saw the printerbed in manufacturing. Drop down do work at that moment .

tanks