Thin wall not created
Quote from dartrax on 2021-11-04, 10:19Version 1.1.1.204 and 1.1.1.209 and 1.1.1.211 and 1.1.2.219
I was not able to have this thin wall (blade wall?) created. Blade wall extrusion width is set to 60%.
When I set Perimeter extrusion width to 60%, the wall gets created (not as thin wall but with two slightly overlapping perimeters), but there are extrusion paths protruding into the holes.
Version 1.1.1.204 and 1.1.1.209 and 1.1.1.211 and 1.1.2.219
I was not able to have this thin wall (blade wall?) created. Blade wall extrusion width is set to 60%.
When I set Perimeter extrusion width to 60%, the wall gets created (not as thin wall but with two slightly overlapping perimeters), but there are extrusion paths protruding into the holes.
Uploaded files:- You need to login to have access to uploads.
Quote from Giovanni Selvaggio on 2021-12-02, 08:37Blade wall is when there is no contour of the model, just a single plane for example. Our thin wall feature is experimental and not yet activated in the release. In future versions we will have this feature.
Blade wall is when there is no contour of the model, just a single plane for example. Our thin wall feature is experimental and not yet activated in the release. In future versions we will have this feature.
Quote from dartrax on 2021-12-20, 10:24Thanks for the clarification regarding blade wall!
However, the extrusion paths protruding into the holes are still an issue, aren't they?
Thanks for the clarification regarding blade wall!
However, the extrusion paths protruding into the holes are still an issue, aren't they?
Quote from Norbert Fekete on 2022-01-03, 13:40Yes, those are still an issue.
Made an issue report for it, we'll be on the fix for this one!
The problem seems to be that it is not cutting the lead-in at holes, and one is right next to it.
Lead-in is automatically being cut if it would start from outside, but apparently it is not expecting a very close hole.
Yes, those are still an issue.
Made an issue report for it, we'll be on the fix for this one!
The problem seems to be that it is not cutting the lead-in at holes, and one is right next to it.
Lead-in is automatically being cut if it would start from outside, but apparently it is not expecting a very close hole.