I'm working on an IDEX XL profile for PrusaSlicer and working through error codes that pop up. X and Y offsets haven't been too bad, but I'm flummoxed by this syntax error.
Error showing on IDEX Screen:
Complete line of gcode referenced by the IDEX:
I can't tell what is wrong with the gcode at the line it's referencing. In fact, that exact same G1 move is carried out in earlier layers without producing an error. I'm assuming that the IDEX sequentially reads the code and stops when it reaches an error.
We're printing hall passes for teachers and the print takes up near the entire bed. When sliced in Craftware it prints fine so it's not the model size.
The PrusaSlicer project, Craftware Pro project, and complete offending gcode are in this google drive folder: LINK (the 3mf for the PrusaSlicer can't be uploaded here so I figured the google drive folder was easier)
Our starting point for the PrusaSlicer profile was from github (here). It didn't work off the bat so we've just been tweaking it slowly but surely. I did post to the issues there, but the user hasn't been active since August 2022.
Edit: Cleaned up some of the picture formatting and here's a screenshot of where the printer should actually be at the time of the syntax error
I'm working on an IDEX XL profile for PrusaSlicer and working through error codes that pop up. X and Y offsets haven't been too bad, but I'm flummoxed by this syntax error.
Error showing on IDEX Screen:
Complete line of gcode referenced by the IDEX:
I can't tell what is wrong with the gcode at the line it's referencing. In fact, that exact same G1 move is carried out in earlier layers without producing an error. I'm assuming that the IDEX sequentially reads the code and stops when it reaches an error.
We're printing hall passes for teachers and the print takes up near the entire bed. When sliced in Craftware it prints fine so it's not the model size.
The PrusaSlicer project, Craftware Pro project, and complete offending gcode are in this google drive folder: LINK (the 3mf for the PrusaSlicer can't be uploaded here so I figured the google drive folder was easier)
Our starting point for the PrusaSlicer profile was from github (here). It didn't work off the bat so we've just been tweaking it slowly but surely. I did post to the issues there, but the user hasn't been active since August 2022.
Edit: Cleaned up some of the picture formatting and here's a screenshot of where the printer should actually be at the time of the syntax error
