Layer Height
Quote from Rick Vanemon on 2022-01-13, 06:27Just a very simple question........Where do I set Layer height in Default? I have a model that is designed to be 14mm high and Craftware Pro printed it at 15+mm. I truly want to like this slicer, but without a tutorial it is just too overwhelming. And I just don't have the time, I have spent a couple hours looking everywhere for a possible setting for layer height.
Just a very simple question........Where do I set Layer height in Default? I have a model that is designed to be 14mm high and Craftware Pro printed it at 15+mm. I truly want to like this slicer, but without a tutorial it is just too overwhelming. And I just don't have the time, I have spent a couple hours looking everywhere for a possible setting for layer height.
Quote from Magori Andras on 2022-01-21, 21:05Dear Rick,
Sadly it's a known Firmware Bug that causes Z shifting when ZHops are used in a Gcode..
The Gcode is correct and the right commands are emitted, but the in case of the Zhops, sometimes a little Zshift occurs (few microns every time), so the modell will be taller without a visible layer jump.
The solution is on the way, the firmware update expected in 2 weeks.
Until that, you can disable the zhops in the craftware Pro by setting all of them to 0. This way you can avoid this problem.
Best Regards,
András
Dear Rick,
Sadly it's a known Firmware Bug that causes Z shifting when ZHops are used in a Gcode..
The Gcode is correct and the right commands are emitted, but the in case of the Zhops, sometimes a little Zshift occurs (few microns every time), so the modell will be taller without a visible layer jump.
The solution is on the way, the firmware update expected in 2 weeks.
Until that, you can disable the zhops in the craftware Pro by setting all of them to 0. This way you can avoid this problem.
Best Regards,
András
Uploaded files:
- You need to login to have access to uploads.