ForumCraftware: TroubleshootingGyroid infill doesn't work

The Forum from now on is in READ ONLY mode. Thank you for participating, but this message board is being sunset.

Gyroid infill doesn't work

#1 · 2022-01-25, 19:00

Even when slicing a cube using the Default FDM profile, changing the infill to Gyroid causes GCode generation to fail when the progress is at about 50%. Changing fill density or subdivision level doesn't help. CraftWare Pro v1.1.3.301. CraftBot FLOW IDEX.

#2 · 2022-03-17, 08:56

Hi!

1.1.4 has been released, which includes the full implementation of the Gyroid infill.

Can you check if the slicing will fail in the new version?