This is an FYI for everyone as it was not noted in the release notes for Flow Version 8522.
When starting a print, the heated bed will heat to the M190 setpoint, and then wait 3 minutes to normalize the temperature across the bed. (This is a good change)
While that is occurring, the hotend will heat to 70% of the M104 set-point. After the 3 minute normalization period of the bed, the active hotend will heat to the M109 set-point prior to starting the print.
This is an FYI for everyone as it was not noted in the release notes for Flow Version 8522.
When starting a print, the heated bed will heat to the M190 setpoint, and then wait 3 minutes to normalize the temperature across the bed. (This is a good change)
While that is occurring, the hotend will heat to 70% of the M104 set-point. After the 3 minute normalization period of the bed, the active hotend will heat to the M109 set-point prior to starting the print.
