Craftbot Plus Bed Height
Quote from Dean Moore on 2023-01-16, 01:12Hi,
II'm trying to level the bed on my Craftbot Plus.
I have turned the 3 height thumb screws all the way up, however, the bed is still too far from the nozzle.
I can manually adjust the height using height bolt but as soon as I go to calibrate, it then goee back down and again the bed and nozzle gap are too far apart.
Is there an adjuster anywhere, so I can raise the bed? With the thumbscrews all the way at the top, theres is no way to make any adjustments.
Thank you.
Hi,
II'm trying to level the bed on my Craftbot Plus.
I have turned the 3 height thumb screws all the way up, however, the bed is still too far from the nozzle.
I can manually adjust the height using height bolt but as soon as I go to calibrate, it then goee back down and again the bed and nozzle gap are too far apart.
Is there an adjuster anywhere, so I can raise the bed? With the thumbscrews all the way at the top, theres is no way to make any adjustments.
Thank you.
Quote from Giovanni Selvaggio on 2023-01-24, 13:01Yes, there is a small piece of L shaped metal which pushes the Z end stop switch. You can adjust its position using hex keys.
Yes, there is a small piece of L shaped metal which pushes the Z end stop switch. You can adjust its position using hex keys.